Used Flat die pellet mill SKJ450

BRY air-cooled centrifugal heat transfer oil pump maintenance should pay attention to ten aspects .1. After using the vacuum oven, be sure to do a clean job, clean the vacuum oven glass.

2. Wipe the exterior anti-rust oil.

3. Eliminate the governor cavity, spray smooth BRY air-cooled centrifugal oil heat pump cavity anti-rust oil, to participate in the rules of the trademark of smooth oil.

4. The anti-rust oil in the fuel pipeline should also be removed before use. Connect the fuel to the micro-pipeline, and move to change the jet camshaft from time to time until the oil valve is tightly closed to emit clean fuel.

5 fuel selection is reasonable.

6 must be marked with the appropriate fuel. Ordinary Yan days use No. 0 diesel fuel, winter use -10 light diesel oil.

7. The fuel used must be clean and contain no impurities or moisture

8. Water will erode the BRY air-cooled centrifugal heat transfer oil pump, so water-containing substances should be prevented from pumping with a BRY air-cooled centrifugal heat transfer oil pump. Use a water pump in Room 1210 to evacuate.

9. Contains a lot of solvent material First in the oven to remove most of the solvent, and then use vacuum.

10. The exact number of the first use of vacuum pumps to avoid the phenomenon of inverted suction.